Soundcare superspikes 601 feet for electronics

Soundcare superspikes 601 feet for electronics, pack of 4pcs

This is the foot for your electronic equipment. The foot can easily replace the original foot on your electronics if it is the type with threads in the middle. The outer diameter is 55 mm.

CD-players, turntables, DVD-players, MD-players, amplifiers, etc. will sound much better with these feet

Soundcare® SuperSpike standard models: The standard SuperSpike is proven to be extremely effective on all Hi-Fi equipments. Soundcare® SuperSpike is a low cost upgrade that will make a major difference to the sound quality of any system. The Standard SuperSpike is made in shiny and black finish.

How it is designed

All Soundcare® spikes are spikes with a rounded tip (0,5 mm in diameter) standing in a crater with

a flat bottom. In this way we get a very small contact area combined with enormous strength.

Load tolerances is only of theoretical interests. For standard spikes you can put 400 kg per spike,

for the TITANIUM models even more.

The Soundcare SuperSpike is an assembly of :

An outer, sturdy, clean looking housing of ABS plastic (standard version) or polycarbonate (High-End version) (1).

Spike made of first class case hardened steel (2).

Zinc casing (3) that reduces resonances in the spike and is specially designed to hold the plastic housing when the equipment is lifted.

Zinc disc (4) with a mild steel insert (5).

Self adhesive felt disc made from 1,25mm quality felt with permanent fairly high coatweight tape.

Double coated tape, 3M 9573 high performance permanent tape (only the self adhesive version).

Lock nut. (only the threaded versions).

The Measurement

Measurements for Soundcare SuperSpikes:

A calibrated loudspeaker has been fed with a sinus wave on each frequency level. The loudspeaker has been placed upon a calibrated pressure sensitive microphone. For each frequency the signal is fed through the loudspeaker and the output level is adjusted to specific level which is referred to as 0 dB. Then the spike is placed between the loudspeaker cabinet and the pressure sensitive microphone. The same signal with the same output level is used. The level from the microphone is then measured. The direct sound through air from the loudspeaker to the microphone is never measured louder than –30 dB for any of the frequencies. The curves will therefore show the approximate transmission of energy from loudspeaker cabinet through the spike and down to the microphone.

In words the damping of acoustic feedback is:

We do not know of any other that has measured spikes this way before. Until now spikes only have been listening tested as far as we know. This is a way to try to measure the benefits in a way that makes it possible to show the results on paper. There can be inaccuracy because of unknown resonances and other unknown influence, but we are sure these results show how spikes reduce acoustic feedback.

The influence of reducing the feedback at one frequency for another is not measured. Listening tests show that reducing feedback at low frequencies does have large influence on the sound quality at higher frequencies. The different models, threaded and self-adhesive have been tested. The results are so similar for the different models that it does not influence the curve. At 50Hz (the most important frequency to damp) we had a reduction of 11 dB, which means that appr. 95% of the feedback energy was stopped.